I need to make several JG Speedfit connections to 1/2" BSP male.
This looks like what I need:-
https://www.toolstation.com/jg-speedfit-straight-tap-connector/p13693
... but will this go onto the sort of male connector where one would
normally use PTFE tape? I.e. it's not like a tap where one would
probably use a rubber washer of some sort to make the seal. The above
looks like it's expecting to have a washer inside it. Am I in the land
of taper BSP as opposed to parallel BSP?
Am I confused or is there a somewhat different type of fitting that I
need?
--
Chris Green
ยท
--- SoupGate-Win32 v1.05
* Origin: fsxNet Usenet Gateway (21:1/5)