XPost: linux.debian.bugs.dist
From:
[email protected]
Package: src:linux
Version: 6.12.32-1
Severity: normal
X-Debbugs-Cc:
[email protected]
Dear Maintainer,
I have Debian Trixie on my laptop and the disk is encrypted, not the /boot/efi partition.
I have been using kernel 6.12.30 for a while without any problem.
There is a new kernel version available, 6.12.32. When I try to boot using this kernel I can see this on the screen:
mmc0: error -110 whilst initialising MMC card
amdgpu 0000:03:00.0: amdgpu: failed to load ucode RLC_RESTORE_LIST_CMTL(0x29) amdgpu 0000:03:00.0: amdgpu: psp gfx command LOAD_IP_PW(0x6) failed and response status is (0xFFFF300F)
...
cryptsetup waiting for encrypted source device UUID=9c16003c-e1b9-4a25-bc5c-74fcbb278fe7...
mdadm: No devices listed in conf file were found
mdadm: No devices listed in conf file were found
mdadm: No devices listed in conf file were found
cryptsetup waiting for encrypted source device UUID=9c16003c-e1b9-4a25-bc5c-74fcbb278fe7...
mdadm: No devices listed in conf file were found
mdadm: No devices listed in conf file were found
mdadm: No devices listed in conf file were found
I don't have any RAID on my laptop.
Adding debug break=mount to GRUB dropped me to a initramfs console where I ran the following commands:
ls /dev and output was "no such file or directory"
ls /dev/mmc* and output was "no such file or directory
ls /dev/disk/by-uuid and output was "no such file or directory
*** Reporter, please consider answering these questions, where appropriate ***
* What led up to the situation?
* What exactly did you do (or not do) that was effective (or
ineffective)?
* What was the outcome of this action?
* What outcome did you expect instead?
*** End of the template - remove these template lines ***
-- Package-specific info:
** Kernel log: boot messages should be attached
** Model information
sys_vendor: HP
product_name: HP Laptop 14s-fq0xxx
product_version:
chassis_vendor: HP
chassis_version: Chassis Version
bios_vendor: AMI
bios_version: F.67
board_vendor: HP
board_name: 87B7
board_version: 28.21
** Configuration for modprobe:
blacklist microcode
blacklist arkfb
blacklist aty128fb
blacklist atyfb
blacklist radeonfb
blacklist cirrusfb
blacklist cyber2000fb
blacklist kyrofb
blacklist matroxfb_base
blacklist mb862xxfb
blacklist neofb
blacklist pm2fb
blacklist pm3fb
blacklist s3fb
blacklist savagefb
blacklist sisfb
blacklist tdfxfb
blacklist tridentfb
blacklist vt8623fb
blacklist microcode
options snd_pcsp index=-2
options cx88_alsa index=-2
options snd_atiixp_modem index=-2
options snd_intel8x0m index=-2
options snd_via82xx_modem index=-2
options md_mod start_ro=1
options bonding max_bonds=0
options dummy numdummies=0
options ifb numifbs=0
** PCI devices:
00:00.0 Host bridge [0600]: Advanced Micro Devices, Inc. [AMD] Raven/Raven2 Root Complex [1022:15d0]
Subsystem: Hewlett-Packard Company Device [103c:87b7]
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
00:00.2 IOMMU [0806]: Advanced Micro Devices, Inc. [AMD] Raven/Raven2 IOMMU [1022:15d1]
Subsystem: Hewlett-Packard Company Device [103c:87b7]
Control: I/O- Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 25
Capabilities: <access denied>
00:01.0 Host bridge [0600]: Advanced Micro Devices, Inc. [AMD] Family 17h (Models 00h-1fh) PCIe Dummy Host Bridge [1022:1452]
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
IOMMU group: 1
00:01.6 PCI bridge [0604]: Advanced Micro Devices, Inc. [AMD] Raven/Raven2 PCIe GPP Bridge [6:0] [1022:15d3] (prog-if 00 [Normal decode])
Subsystem: Hewlett-Packard Company Device [103c:87b7]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin ? routed to IRQ 26
IOMMU group: 2
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: f000-ffff [size=4K] [16-bit]
Memory behind bridge: fcf00000-fcffffff [size=1M] [32-bit]
Prefetchable memory behind bridge: [disabled] [64-bit]
Secondary status: 66MHz- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- <SERR- <PERR-
BridgeCtl: Parity- SERR+ NoISA- VGA- VGA16+ MAbort- >Reset- FastB2B-
PriDiscTmr- SecDiscTmr- DiscTmrStat- DiscTmrSERREn-
Capabilities: <access denied>
Kernel driver in use: pcieport
00:01.7 PCI bridge [0604]: Advanced Micro Devices, Inc. [AMD] Raven/Raven2 PCIe GPP Bridge [6:0] [1022:15d3] (prog-if 00 [Normal decode])
Subsystem: Hewlett-Packard Company Device [103c:87b7]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin ? routed to IRQ 27
IOMMU group: 3
Bus: primary=00, secondary=02, subordinate=02, sec-latency=0
I/O behind bridge: 1000-1fff [size=4K] [16-bit]
Memory behind bridge: f0200000-f03fffff [size=2M] [32-bit]
Prefetchable memory behind bridge: f0400000-f05fffff [size=2M] [32-bit]
Secondary status: 66MHz- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- <SERR- <PERR-
BridgeCtl: Parity- SERR+ NoISA- VGA- VGA16+ MAbort- >Reset- FastB2B-
PriDiscTmr- SecDiscTmr- DiscTmrStat- DiscTmrSERREn-
Capabilities: <access denied>
Kernel driver in use: pcieport
[continued in next message]
--- SoupGate-Win32 v1.05
* Origin: you cannot sedate... all the things you hate (1:229/2)