1. Forum
  2. Usenet
  3. COMP.SYS.MAC.PRINTING

  • Resetting printer

    From Daniel Cohen@21:1/5 to All on Fri Sep 7 09:55:07 2018
    HP's instruction for resetting a Photosmart printer include the
    following

    Remove power cord from printer

    Then remove power cord from wall socket

    and then reconnect to wall socket and finally reconnect to printer.

    I am wondering why the power cord needs to be removed from the wall
    socket after it has been removed from the printer. Is it just a matter
    of safety, or does it actually reset something?

    This is for a friend, who is not particularly mobile, and it would be a
    lot easier if she does not have to get to the socket, which is
    underneath a desk.

    I'm the kind of person who tends to follow instructions, but I can't see
    the point of this one.

    --
    <http://www.decohen.com>
    The Labyrinth of the Heart: Changed Myths for Changing Lives
    book and e-book <http://www.decohen.com/labyrinth.htm>
    Send e-mail to the Reply-To address, not the From address.

    --- SoupGate-Win32 v1.05
    * Origin: fsxNet Usenet Gateway (21:1/5)
  • From Wolffan@21:1/5 to Daniel Cohen on Fri Sep 7 07:57:11 2018
    On 07 Sep 2018, Daniel Cohen wrote
    (in article<1nur4nn.175l2cysoznrhN%[email protected]>):

    HP's instruction for resetting a Photosmart printer include the
    following

    Remove power cord from printer

    Then remove power cord from wall socket

    and then reconnect to wall socket and finally reconnect to printer.

    I am wondering why the power cord needs to be removed from the wall
    socket after it has been removed from the printer. Is it just a matter
    of safety, or does it actually reset something?

    This is for a friend, who is not particularly mobile, and it would be a
    lot easier if she does not have to get to the socket, which is
    underneath a desk.

    I'm the kind of person who tends to follow instructions, but I can't see
    the point of this one.

    You can _probably_ get away with just unplugging at the printer. The printer has ’soft power’, which means that there’s always power on inside even when you hit the ‘off’ button, unless you unplug it. Unplugging from both ends is something the paranoid do, so that when the power cable is plugged
    back in again they _know_ that it’s plugged in firmly, properly, and in the correct sockets. (You would not _believe_ the number of printer and computer problems I’ve seen which were caused by wrong cable/port, or not properly inserted cable, or combination)

    If the printer is plugged into a surge protector or a power strip, hitting
    the ‘off’ switch there will probably work, too, as long as the cable was properly inserted in the first place.

    --- SoupGate-Win32 v1.05
    * Origin: fsxNet Usenet Gateway (21:1/5)