I upgraded my power supplies in my model 3 (since the originals
smoked/caug
on fire}. Everything looks good when I reboot EXCEPT now the
previously
working floppy drives no longer do. I tested the power supply
voltages and
they look okay. I hooked
up several different floppy drives and they all do the same
thing....basica
nothing. When I boot the crt says "Diskette?" and the floppy drive
is
connected but the led never lights up or spins...I don't think its
a bad
floppy drive as it used to more
or less work (some errors, needed cleaning} when booting before I
took the
model 3 apart. Any ideas? Please don't tell me it's the floppy controller....much more cost/work to fix that.
Jeff, the smoke likely is nothign to be concerned on your model 3 power supplies, it is usually teh RIFA Capacitors (power line filters) that
look
lioke yellow semi tranparent rectangles, cut them off and replace or
use
psu without them to test.
regarding your floppy drive not working, Iwould open case and examine
the
flat ribbon cable that runs between motherboard and floppy disk
controller
to make sure its not rotten. I also suggest disconnectingthe top drive
and
make sure your not using a twisted cable for your floppy drive.
the fdc when it fails, simply will make your mdel 3 boot directly to
CASS?
if it doesnt then it may still be teh FDC but liekly something else,
caps on
floppies can burn out.
Patrick B. TTR ( the TexasTandyRestoration.org shop you were talking
about.
--- SoupGate-Win32 v1.05
* Origin: fsxNet Usenet Gateway (21:1/5)