From Louis Ohland@21:1/5 to All on Fri Jul 11 12:53:31 2025
Both front mounting posts twisted off right where they met the
horizontal frame and the JB PlasticWeld squeezed a little into the space between the parts. WD40 Specialist Dry Lube did a good job of keeping
the torque needed to screw in the screws to a reasonable level...
Got back from Ace Hardware, used .125" thick nylon washers [Hillman] to
space the front frame screws' captive metal washer. Used two nylon
washers, a smaller OD nestled inside a larger ID to fill the entire area
under the captive metal washer.